APPLICATION GUIDE
Establish where you would best like your soft pad eyes. For most things you would want to carry on your board a spacing of 300mm x 300mm is recommended.
Place application stickers where your soft pad eyes will go (leaving one corner un-stuck) and sand with 60-120 grit sand paper. Then clean with alcohol.
Apply glue to both soft pad eye and surface that it will be stuck to. Push down until an even squeeze out is seen. Clean excess glue away and then remove application sticker. Check for any signs of glue again.
Allow to dry (between 1 hour and 24 hours depending on what glue you have used).
Copyright 2012 © All Rights Reserved
+61 0413304217 WWW.STIC-IT.COM INFO@STIC-IT.COM